Section 968 (Door System - Front): Latch: Removal
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
- Remove door trim panel and watershield. (Refer to REMOVAL ) and (Refer to REMOVAL ).
- Raise door glass.
- Disconnect clips holding key cylinder and latch rods to outside door handle (Figure ).
- Disengage wire connector from power door lock motor and push pin from latch.
- Disengage push pin fasteners attaching key position switch wire to the latch, if equipped.
- Remove screws attaching latch to door inner panel.
- Remove door latch from door, using care not to damage cables or rods.