FixVault
Home › Toyota › 2004 › Matrix Base, FWD, Standard › Repair and Diagnosis › External Pages › Different car › Section 946 (Power Liftgate System) › Full Open Switch › Removal

Full Open Switch: Removal

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the left rear D-pillar trim panel from the vehicle. Refer to D-PILLAR TRIM .
    CAUTION: Locate the two wires coming from the full open switch. On a piece of paper, note the wire color and cavity the wires are currently installed in on both the switch and connector side of the harness. This will prove helpful later.
  4. Cut the two wires leading to the full open switch and back the wires out of the drive unit's main electrical connector. Refer to SYSTEM WIRING DIAGRAMS .
  5. Using needle nose pliers, depress the full open switch's plastic retaining tabs and remove the full open switch from the drive unit assembly.
About FixVault