FixVault
Home › Toyota › 2004 › Matrix Base, FWD, Standard › Repair and Diagnosis › External Pages › Different car › Section 948 (Power Seat System) › Driver Seat Switch › Removal

Driver Seat Switch: Removal

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the front door trim panel. Refer to TRIM PANEL .
  3. Disconnect the wire harness connector from the door module. Depress the retaining tab and pull straight apart.
  4. Press in the four clips that secure the seat switch to the door trim panel.
  5. Remove the power seat switch from the trim panel.
About FixVault