FixVault
Home › Toyota › 2004 › Matrix Base, FWD, Standard › Repair and Diagnosis › External Pages › Different car › Section 972 (Seat System) › Front Seat Back › Removal

Front Seat Back: Removal

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable.
  2. Remove seat from vehicle. (Refer to REMOVAL  ).
  3. Remove the armrest. (Refer to REMOVAL  ).
  4. Remove screw attaching front cushion shield and remove shield.
  5. Remove seat back panel from seat. (Refer to REMOVAL  ).
  6. Remove three screw attaching side cushion cover and remove cover, if equipped. (Refer to REMOVAL  ).
  7. Disengage J-straps at seat back cover opening for partial detrain of cover, to access seat back mounting screws.
  8. Remove seat back mounting screws (Fig 1 ).
    9. Fig 1: Removing Seat Back Mounting Screws
    G03571793Courtesy of DAIMLERCHRYSLER CORP.
  9. Remove seat back by pulling upward from seat assembly (Fig 2 ).
    10. Fig 2: Removing Front Seat Back Side Cover
    G03571794Courtesy of DAIMLERCHRYSLER CORP.
About FixVault