VSV For Evaporative Emission (EVAP): Inspection

REMOVE VSV
INSPECT VSV
1. Inspect the VSV for open circuit.
  Using an ohmmeter, check that there is continuity between the terminals.
  
  Resistance: 30 to 34 Ω at 20°C (68°F)
  
  Fig 1: Checking Continuity Between Terminals Using Ohmmeter
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  If there is no continuity, replace the VSV.
2. Inspect the VSV for ground.
  Using an ohmmeter, check that there is no continuity between each terminal and the VSV body.
  
  Fig 2: Checking For No Continuity Between Each Terminal And VSV Body Using Ohmmeter
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  If there is continuity, replace the VSV.
3. Inspect the VSV operation.
  1. Check that air flows with a little difficulty from ports E to F.
    
    Fig 3: Checking Air Flows From Ports E To F
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Apply battery positive voltage to the terminals.
  3. Check that air flows from ports E to F.
    
    Fig 4: Applying Battery Positive Voltage To Terminals & Checking Air Flows From Ports E To F
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    
    If the operation is not as specified, replace the VSV.
REINSTALL VSV