FixVault
Home › Toyota › 2004 › Sequoia Limited, 4WD › Repair and Diagnosis › Body & Frame › Body, Cab Control Systems › Driver Door Control System - Diagnostics › Circuit Inspection › Window lock switch circuit › Inspection Procedure

Inspection Procedure

  1. Check the window lock switch circuit using DTC check (See  HOW TO PROCEED WITH TROUBLESHOOTING  ). 
    1. OK: Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  or  PROBLEM SYMPTOMS TABLE   ). 
    2. NG: Go to next step. 
  2. Check wire harness and connector between driver door ECU and passenger door ECU (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. NG: Repair or replace wire harness or connector. 
    2. OK: Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE   ). 
About FixVault