FixVault
Home › Toyota › 2004 › Sequoia SR5, 4WD › Repair and Diagnosis › Body & Frame › Body, Cab Control Systems › Body Control Systems - Diagnostics › Circuit Inspection › Automatic light control sensor circuit › Inspection Procedure

Inspection Procedure

  1. Check automatic light control sensor (See  INSPECTION  ). 
    1. NG: Replace automatic light control sensor. 
    2. OK: Go to next step. 
  2. Check harness and connector between automatic light control sensor and body ECU (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. NG: Repair or replace wire harness or connector. 
    2. OK: Go to next step. 
  3. Does the system operate normally after replacement of automatic light control sensor. 
    1. Yes: Replace automatic light control sensor. 
    2. NO: Proceed to next inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE   ). 
About FixVault