Driver Door Control System - Diagnostics: Pre-Check
- DATA LIST
HINT:
Using the hand-held tester DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to shorten labor time.
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch ON.
- Read the DATA LIST according to the display on the tester.
DATA LISTItem Measurement Item/Display (Range) Normal Condition D P/W AUTO SW P/W auto SW signal/ ON or OFF ON: P/W auto DOWN SW is ON OFF: P/W auto DOWN SW is OFF LOCK POS SW Lock position SW signal/ ON or OFF ON: Door lock is in unlock position OFF: Door lock is in lock position - ACTIVE TEST
HINT:
Performing the hand-held tester ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to shorten the labor time. The DATA LIST can be displayed during the ACTIVE TEST.
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch ON.
- Perform the ACTIVE TEST according to the display on the tester.
ACTIVE TESTItem Test Details Diagnostic Note P/W UP/DOWN Drive P/W motor UP/DOWN Refer to DATA LIST for details)