How To Proceed With Troubleshooting

HINT:

• Use this procedure to troubleshoot the power door lock system.
• The hand-held tester should be used in steps  4 and  6.

1. VEHICLE BROUGHT TO WORKSHOP 
   1. NEXT: Go to next step 
2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK 
   1. NEXT: Go to next step 
3. PROBLEM SYMPTOMS TABLE (See  PROBLEM SYMPTOMS TABLE   ) 
   1. If the fault is not listed on the problem symptoms table, proceed to A.
   2. If the fault is listed on the problem symptoms table, proceed to B.
   1. B: Go to step   5 
   2. A: Go to next step 
4. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. DATA LIST/ACTIVE TEST (see DATA LIST/ACTIVE TEST  ).
      1. Inspection with the hand-held tester (DATA LIST).
      2. Inspection with the hand-held tester (ACTIVE TEST).
   2. Terminals of ECU (see TERMINALS OF ECU  ).
   3. On-vehicle inspection (see ON-VEHICLE INSPECTION ).
   4. Inspection (see INSPECTION ).
   1. NEXT: Go to next step 
5. ADJUST, REPAIR OR REPLACE 
   1. NEXT: Go to next step 
6. CONFIRMATION TEST 
   1. NEXT: END