FixVault
Home › Toyota › 2005 › Avalon XLS › Repair and Diagnosis › Body & Frame › Ignition Switch/Steering Lock › Electric Steering Lock › Power Source Circuit › Inspection Procedure

Inspection Procedure

  1. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSY - BODY GROUND) 
    1. Disconnect the D14 connector from the steering lock actuator assy.
    2. Measure the resistance according to the value (s) in the table below.

      Standard: 

      TESTER CONNECTION AND SPECIFIED CONDITION

      Tester connection (Symbols) Condition Specified condition
      D14-1 (GND) - Body ground Always Below 1 Ω
      D14-2 (SGND) - Body ground Always Below 1 Ω
      Fig 1: Identifying Steering Lock Actuator Assy Connector Terminals
      G02976833Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 
    2. OK: Go to next step. 
  2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSY - BATTERY) 
    1. Measure the voltage according to the value (s) in the table below.

      Standard: 

      TESTER CONNECTION AND SPECIFIED CONDITION

      Tester connection (Symbols) Condition Specified condition
      D14-7 - D14-1 (GND) Always 10 to 14 V
      D14-7 - D14-2 (SGND) Always 10 to 14 V
      Fig 2: Checking Harness & Connector (Steering Lock Actuator Assy - Battery)
      G02976834Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (SEE  PROBLEM SYMPTOMS TABLE  ) 
    2. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (STEERING LOCK ACTUATOR ASSY - BATTERY) 
About FixVault