Inspection Procedure

Fig 1: Identifying Ignition Or Starter Switch Assy Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Measure the resistance of the ignition switch.
   TESTER CONNECTION SPECIFIED CONDITION CHART (1 OF 3)
   
   

   Tester Connection	Switch Condition	Specified Condition
   -	LOCK	-
   1 - 3	ACC	Below 1 Ω
   1 - 2 - 3	ON	Below 1 Ω
   5 - 6	ON	Below 1 Ω
   1 - 2	START	Below 1 Ω
   4 - 5 - 6	START	Below 1 Ω

   1. NG: REPAIR OR REPLACE IGNITION OR STARTER SWITCH ASSY 

   OK: Go to next step 

1. Remove the fuse from the instrument panel J/B.
   Fig 2: Removing Fuse From Instrument Panel J/B

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance of the fuse.

   Standard: Below 1 Ω 

1. NG: REPLACE FUSE 

OK: Go to next step 

1. Remove the IG relay from the instrument J/B.
   Fig 3: Removing IG Relay From Instrument J/B

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance of the relay.
   TESTER CONNECTION SPECIFIED CONDITION CHART (2 OF 3)
   
   

   Tester Connection	Specified Condition
   3-5	10 kΩ or higher
   3-5	Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

   1. NG: REPLACE RELAY 

OK: Go to next step 

1. Disconnect the T3 TVIP ECU connector.
   Fig 4: Disconnecting T3 TVIP ECU Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the ignition switch ON.
3. Measure the voltage of the wire harness side connector.
   TESTER CONNECTION SPECIFIED CONDITION CHART (3 OF 3)
   
   

   Tester Connection	Specified Condition
   IG(T3-10)- Body ground	10 to 14V

1. NG: REPAIR OR REPLACE WIRE HARNESS AND CONNECTOR 

OK: Go to next step 

CHECK AND REPLACE TVIP ECU (See  ELECTRONIC CIRCUIT INSPECTION PROCEDURE  )