Inspection Procedure

1. Disconnect the C11 connector.
2. Measure the resistance according to the value(s) in the table below.
   TESTER CONNECTIONS SPECIFIED CONDITIONS CHART (1 OF 2)
   
   

   Tester connection	Condition	Specified condition
   C11-40 - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.
   Fig 1: Disconnecting C11 Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go To Next Step 

REPLACE COMBINATION METER ASSY (SEE  COMBINATION METER ASSY  )