Reset Inclination Sensor Inside Combination Meter

1. After replacing the part, install the combination meter to the vehicle.
2. Park the vehicle in a flat area (A surface with an angle of inclination no greater than +/-0.5°)
3. With the ignition switch OFF, press the trip switch.
4. While pressing the trip switch, turn the ignition switch to the ON position.
5. Within 5 seconds after the ignition switch is turned ON, release the trip switch and press the trip switch again 3 times, but hold the switch for 5 seconds on the third press. (A buzzer of 800 Hz will sound for 1 second.)
6. After the buzzer stops, release the trip switch.
7. Within 30 seconds after buzzer stops, press the trip switch one more time and hold it for 5 seconds. (Once more, a buzzer of 800 Hz will sound for 1 second.)
8. The horizontal setting is now completed.

HINT:

If a buzzer higher than that of step (e) sounds continually at step (g), turn the ignition switch OFF and perform the setting procedure from step (c) again.