How To Proceed With Troubleshooting

HINT:

The intelligent tester can be used at steps  3,  4,  6, and  9.

1. Vehicle Brought to Workshop 

   NEXT 

2. Customer Problem Analysis 

   NEXT 

3. Connect the OBD II scan tool or intelligent tester to DLC3 

   NEXT 

4. Check and Clear DTCs and Freeze Frame Data 

   HINT:

   (See DTC CHECK / CLEAR ).

   NEXT 

5. Visual Inspection 

   NEXT 

6. Setting the Check Mode Diagnosis 

   HINT:

   (See CHECK MODE PROCEDURE ).

   NEXT 

7. Problem Symptom Confirmation 

   HINT:

   (See ROAD TEST ).

   Symptom does not occur: Go to step 8 

   Symptom occurs: Go to step  9

8. Symptom Simulation 

   HINT:

   (See HOW TO PROCEED WITH TROUBLESHOOTING ).

   NEXT 

9. DTC Check 

   HINT:

   (See DTC CHECK / CLEAR ).

   DTC is not output: Go to step 10 

   DTC is output: Go to step  17

10. Basic Inspection 

    HINT:

    (See ON-VEHICLE INSPECTION  , INSPECTION  and ADJUSTMENT ).

    NG: Go to step  19

    OK: Go to next step 

11. Mechanical System Test 

    HINT:

    (See MECHANICAL SYSTEM TESTS ).

    NG: Go to step  16

    OK: Go to next step 

12. Hydraulic Test 

    HINT:

    (See HYDRAULIC TEST ).

    NG: Go to step  16

    OK: Go to next step 

13. Manual Shifting Test 

    HINT:

    (See INITIALIZATION ).

    NG: Go to step  15

    OK: Go to next step 

14. Problem Symptoms Table Chapter 1 

    HINT:

    (See PROBLEM SYMPTOMS TABLE ).

    NG: Go to step  18

    OK: Go to next step 

15. Problem Symptoms Table Chapter 2 

    HINT:

    (See PROBLEM SYMPTOMS TABLE ).

    NEXT 

16. Part Inspection 

    Go to step   19 . 

17. DTC Chart 

    HINT:

    (See DIAGNOSTIC TROUBLE CODE CHART ).

    NEXT 

18. Circuit Inspection 

    NEXT 

19. Repair or Replace 

    NEXT 

20. Confirmation Test 

    NEXT: End