Inspection Procedure

CHECK BLUETOOTH SETTINGS
1. Check if the BLUETOOTH settings are correct.
  OK: BLUETOOTH settings are correct.
- NG: SET SETTINGS CORRECTLY
- OK: GO TO NEXT STEP
CHECK CELLULAR PHONE
1. Check if the cellular phone is BLUETOOTH capable.
  HINT:
  
  Some versions of BLUETOOTH capable cellular phones may not be compatible.
  
  OK: The phone is BLUETOOTH capable.
- NG: END (ONLY A BLUETOOTH CAPABLE CELLULAR PHONE CAN BE USED)
- OK: GO TO NEXT STEP
CHECK SETTINGS
1. Check if the cellular phone functions.
  HINT:
  - The cellular phone is unable to make a call under any of the following conditions.
  - The cellular phone is locked.
  - The dictionary is being transferred.
  - The line is crossed.
  - Transmission is requested.
  - The power is off.
  - The cellular phone is not connected to BLUETOOTH ("BT" is displayed while a connection is present).
    OK: No of the above conditions exist.
- NG: SET SETTING CORRECTLY
- OK: GO TO NEXT STEP
CHECK CELLULAR PHONE
1. Check if the cellular phone can make a call.
  HINT:
  
  When the battery charge is low, calls cannot be made or received.
  
  OK: The cellular phone can make a call.
- NG: REPLACE CELLULAR PHONE
- OK: GO TO NEXT STEP
CHECK RECEPTION
1. Put a cellular phone into a receiving state.
2. Place the cellular phone close to the multi-display.
3. Check if the cellular phone has reception according to the multi-display.
  OK: The cellular phone has reception.
- NG: REPLACE MULTI-DISPLAY
- OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE