Inspection Procedure

1. Check if the Bluetooth settings are correct.

   OK : 

   Bluetooth settings are correct. 

NG : SET SETTINGS CORRECTLY 

OK : GO TO NEXT STEP 

1. Check if the cellular phone is Bluetooth compatible.

   HINT:

   Some versions of Bluetooth compatible cellular phones may not function.

   OK : 

   Phone is Bluetooth compatible. 

NG : END (ONLY A BLUETOOTH COMPATIBLE CELLULAR PHONE CAN BE USED) 

OK : GO TO NEXT STEP 

1. Check if the cellular phone functions.

   HINT:

   The cellular phone is unable to call under any of the following conditions.

   • The cellular phone is locked.
   • The directory is being transferred.
   • The line is crossed.
   • Transmission is regulated.
   • The power is OFF.
   • The cellular phone is not connected to Bluetooth ("Bluetooth mark" is displayed while connected).

   OK : 

   Above conditions do not exist. 

NG : SET CORRECTLY 

OK : GO TO NEXT STEP 

1. Check if the cellular phone can call.

   HINT:

   When the battery is low, calls cannot be made or received.

   OK : 

   Cellular phone can call. 

NG : REPLACE CELLULAR PHONE 

OK : GO TO NEXT STEP 

1. Set the cellular phone so that it can receive calls.
2. Place the cellular phone close to the multi-display.
3. Check if the cellular phone has reception according to the multi-display.

   OK : 

   Cellular phone has reception. 

NG : REPLACE MULTI-DISPLAY 

OK : GO TO NEXT STEP 

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN  PROBLEM SYMPTOMS TABLE