FixVault
Home › Toyota › 2006 › Sequoia Limited, 4WD › Repair and Diagnosis › External Pages › Different car › Section 38 (Cruise Control System) › Cruise Control System › Road Test

Road Test

WARNING: This page is about a different car, the 2006 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. PROBLEM SYMPTOM CONFIRMATION 
    1. Inspect the SET switch.
      1. Push the main switch button ON.
      2. Drive at a desired speed (40 km/h (25 mph) or higher).
      3. Push down the control switch to the -/SET position.
      4. After releasing the switch, check that the vehicle cruises at the desired speed.
        Fig 1: Inspecting SET Switch
        G04494739Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Inspect the '+' switch.
      1. Push the main switch button ON.
      2. Drive at a desired speed (40 km/h (25 mph) or higher).
      3. Check that the vehicle speed increases when the control switch is pushed up to +/RES, and that the vehicle cruises at the set speed when the switch is released.
      4. Push the control switch to +/RES, and then immediately release it. Check that the vehicle speed increases by about 1.6 km/h (Tap-up function).
        Fig 2: Inspecting '+' Switch
        G04494740Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Inspect the '-' switch.
      1. Push the main switch button ON.
      2. Drive at a desired speed (40 km/h (25 mph) or higher).
      3. Check that the vehicle speed decreases while the control switch is pushed down to -/SET, and the vehicle cruises at the set speed when the switch is released.
      4. Push the control switch to -/SET, and then immediately release it. Check that the vehicle speed decreases by about 1.6 km/h (Tap-down function).
        Fig 3: Inspecting '-' Switch
        G04494741Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Inspect the CANCEL switch.
      1. Push the main switch button ON.
      2. Drive at a desired speed (40 km/h (25 mph) or higher).
      3. After doing one of the following, check that the cruise control system is cancelled and that the normal driving mode is reset.
        • Depressing the brake pedal.
        • Shift to any gear besides D.
        • Pushing the main switch button OFF.
        • Pulling the control switch CANCEL.
          Fig 4: Inspecting CANCEL Switch
          G04494742Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Inspect the RES switch.
      1. Push the main switch button ON.
      2. Drive at a desired speed (40 km/h (25 mph) or higher).
      3. After doing one of the following, check that the cruise control system is cancelled and that the normal driving mode is reset.
        • Depressing the brake pedal.
        • Shift to any gear besides D.
        • Pulling the control switch CANCEL.
      4. After the control switch is pulled up to +/RES at the driving speed of more than 40 km/h (25 mph), check that the vehicle resumes the same speed maintained before the cancellation.
        Fig 5: Inspecting RES Switch
        G04494743Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault