FixVault
Home › Toyota › 2007 › 4Runner Limited, 4.7 T, AWD › Repair and Diagnosis › Suspension › Suspension Control Systems › Suspension Control › Height Control Dryer › Installation

Height Control Dryer: Installation

  1. INSTALL HEIGHT CONTROL DRYER ASSEMBLY 
    1. Install the bolt, the dryer and a new O-ring.

      Torque: 6.4 N*m (65 kgf*cm, 57 in.*lbf) 

    2. Assemble the height control compressor, the dryer and the bracket as a unit to the vehicle, and tighten the 3 bolts to fix the bracket to the frame.

      Torque: 29 N*m (300 kgf*cm, 21 ft.*lbf) 

    3. Install the height control compressor assembly to the bracket with the 3 bolts.

      Torque: 5.9 N*m (60 kgf*cm, 52 in.*lbf) 

      Fig 1: Identifying Height Control Compressor Assembly With Bracket & Bolts
      G04964533Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Connect the connector.
  2. CONNECT HEIGHT CONTROL TUBE NO. 2  (See INSTALLATION  )
  3. INSTALL HEIGHT CONTROL FILTER  (See INSTALLATION  )
  4. INSTALL HEIGHT CONTROL COMPRESSOR COVER  (See INSTALLATION  )
  5. CHECK AIR LEAK  (See ON-VEHICLE INSPECTION  )
  6. INSTALL SPARE DISC WHEEL 
  7. INSTALL FUEL TANK FILLER PIPE PROTECTOR  (See INSTALLATION  )
  8. INSTALL REAR BUMPER  (See INSTALLATION )
  9. INSTALL QUARTER PANEL MUDGUARD SUB-ASSEMBLY REAR LH 
  10. INSTALL REAR DISC WHEEL 

    Torque: 112 N*m (1,140 kgf*cm, 83 ft.*lbf) 

About FixVault