FixVault

Data List / Active Test

  1. DATA LIST 

    HINT:

    With the intelligent tester connected to the DLC3 and the ignition switch on (IG), the ABS, TRAC and VSC data list can be displayed. Follow the prompts on the intelligent tester screen to access the DATA LIST.

    DATA LIST

    Item Measurement Item / Range (Display) Normal Condition Diagnostic Note
    ABS MOT RELAY ABS motor relay / ON or OFF ON: Motor relay ON
    OFF: Motor relay OFF
    -
    SOL RELAY Solenoid relay / ON or OFF ON: Solenoid relay ON
    OFF: Solenoid relay OFF
    -
    IDLE SW Main idle switch / ON or OFF ON: Accelerator pedal released
    OFF: Accelerator pedal depressed
    -
    STOP LIGHT SW Stop light switch / ON or OFF ON: Brake pedal depressed
    OFF: Brake pedal released
    -
    PKB SW Parking brake switch / ON or OFF ON: Parking brake applied
    OFF: Parking brake released
    -
    ABS OPERT FR ABS operation (FR) / BEFORE or OPERATE BEFORE: No ABS operation (FR)
    OPERATE: During ABS operation (FR)
    -
    ABS OPERT FL ABS operation (FL) / BEFORE or OPERATE BEFORE: No ABS operation (FL)
    OPERATE: During ABS operation (FL)
    -
    ABS OPERT RR ABS operation (RR) / BEFORE or OPERATE BEFORE: No ABS operation (RR)
    OPERATE: During ABS operation (RR)
    -
    ABS OPERT RL ABS operation (RL) / BEFORE or OPERATE BEFORE: No ABS operation (RL)
    OPERATE: During ABS operation (RL)
    -
    WHEEL SPD FR Wheel speed sensor (FR) reading / min.: 0 mph (0 km/h), max.: 202 mph (326 km/h) Actual wheel speed Similar speed as indicated on speedometer
    WHEEL SPD FL Wheel speed sensor (FL) reading / min.: 0 mph (0 km/h), max.: 202 mph (326 km/h) Actual wheel speed Similar speed as indicated on speedometer
    WHEEL SPD RR Wheel speed sensor (RR) reading / min.: 0 mph (0 km/h), max.: 202 mph (326 km/h) Actual wheel speed Similar speed as indicated on speedometer
    WHEEL SPD RL Wheel speed sensor (RL) reading / min.: 0 mph (0 km/h), max.: 202 mph (326 km/h) Actual wheel speed Similar speed as indicated on speedometer
    DECELERAT SEN Acceleration sensor 1 reading / min.: -1.869 G, max.: 1.869 G Approximately 0 +- 0.13 G while stationary Reading changes when vehicle is bounced
    DECELERAT SEN2 Acceleration sensor 2 reading / min.:-1.869 G, max.: 1.869 G Approximately 0 +- 0.13 G while stationary Reading changes when vehicle is bounced
    IG VOLTAGE ECU power supply voltage / TOO LOW / NORMAL / TOO HIGH TOO HIGH: 14.0 V or more
    NORMAL: 9.5 V to 14.0 V
    TOO LOW: 9.5 V or less
    -
    SFRR ABS solenoid (SFRR) / ON or OFF ON: Operates
    OFF: Does not operate
    -
    SFRH ABS solenoid (SFRH) / ON or OFF ON: Operates
    OFF: Does not operate
    -
    SFLR ABS solenoid (SFLR) / ON or OFF ON: Operates
    OFF: Does not operate
    -
    SFLH ABS solenoid (SFLH) / ON or OFF ON: Operates
    OFF: Does not operate
    -
    SRRR (SRR) ABS solenoid (SRRR (SRR)) / ON or OFF ON: Operates
    OFF: Does not operate
    -
    SRRH (SRH) ABS solenoid (SRRH (SRH)) / ON or OFF ON: Operates
    OFF: Does not operate
    -
    SRLR ABS solenoid (SRLR) / ON or OFF ON: Operates
    OFF: Does not operate
    -
    SRLH ABS solenoid (SRLH) / ON or OFF ON: Operates
    OFF: Does not operate
    -
    SMF (BA-SOL) TRC solenoid (SMF) / ON or OFF ON: Operates
    OFF: Does not operate
    -
    SMR TRC solenoid (SMR) / ON or OFF ON: Operates
    OFF: Does not operate
    -
    ENGINE SPD Engine speed / min.: 0 rpm max.: 6000 rpm Actual engine speed -
    VEHICLE SPD Maximum wheel speed sensor reading / min.: 0 mph(0 km/h), max.: 202 mph (326 km/h) Actual vehicle speed Speed indicated on speedometer
    YAW RATE Yaw rate sensor/ Min.: -128 deg/s, Max.: 127 deg/s Min.: -128 deg/s
    Max.: 127 deg/s
    -
    YAW ZERO VALUE Memorized zero value/ Min.: -128 deg/s, Max.: 127 deg/s Min.:-128 deg/s
    Max.: 127 deg/s
    -
    STEERING ANG Steering sensor/ Min.: -1152 deg,, Max.: 1150.875 deg Left turn: Increase
    Right turn: Decrease
    -
    MAS CYL PRS1 Master cylinder pressure sensor 1 reading / min.: 0 V, Max.: 5 V When brake pedal is released : 0.3 to 0.9 V Reading increases when brake pedal is depressed
    ACCELERATOR % The difference of a present accelerator / min.: 0 %, max.: 128% - -
    TORQUE Real output torque / min.: -1024, max.: 1016 N*m - -
    TEST MODE Test mode / NORMAL or TEST NORMAL: Normal mode
    TEST: During test mode
    -
    SPD SEN FR FR speed sensor open detection / OPN DET or NORMAL OPN DET: Momentary interruption
    NORMAL: Normal
    -
    SPD SEN FL FL speed sensor open detection / OPN DET or NORMAL OPN DET: Momentary interruption
    NORMAL: Normal
    -
    SPD SEN RR RR speed sensor open detection / OPN DET or NORMAL OPN DET: Momentary interruption
    NORMAL: Normal
    -
    SPD SEN RL RL speed sensor open detection / OPN DET or NORMAL OPN DET: Momentary interruption
    NORMAL: Normal
    -
    EFI COM EFI communication open detection / OPN DET or NORMAL OPN DET: Momentary interruption
    NORMAL: Normal
    -
    YAWRATE SEN Yaw rate sensor open detection / OPN DET or NORMAL OPN DET: Momentary interruption
    NORMAL: Normal
    -
    DESELE SEN G sensor open detection / OPN DET or NORMAL OPN DET: Momentary interruption
    NORMAL: Normal
    -
    STEERING SEN Steering sensor open detection / OPN DET or NORMAL OPN DET: Momentary interruption
    NORMAL: Normal
    -
    M/C SEN1 Master cylinder pressure sensor 1 open detection / OPN DET or NORMAL OPN DET: Momentary interruption
    NORMAL: Normal
    -
    INSPECTION MODE Inspection mode condition / INSPECT or OTHER INSPECT: During inspect
    OTHER: No inspect mode
    -
    #IG ON2 Number of IG ON (Inspection mode) / min.: 0, max.:255 0 to 255  
  2. ACTIVE TEST 

    HINT:

    Performing the ACTIVE TEST using the intelligent tester allows the relay, actuator, etc. to operate without removing any parts. Performing the ACTIVE TEST as the first step of troubleshooting is one of the methods to shorten labor time.

    It is possible to display the DATA LIST during the ACTIVE TEST.

    1. Connect the intelligent tester to the DLC3.
    2. Turn the ignition switch on (IG).
    3. According to the display on the tester, perform the "ACTIVE TEST".

      HINT:

      The ignition switch must be turned on (IG) to proceed to the ACTIVE TEST using the intelligent tester.

ACTIVE TEST

Item Vehicle Condition / Test Details Diagnostic Note
SFRR Turns ABS solenoid (SFRR) ON / OFF Operating sound of solenoid (clicking sound) is heard
SFRH Turns ABS solenoid (SFRH) ON / OFF Operating sound of solenoid (clicking sound) is heard
SFLR Turns ABS solenoid (SFLR) ON / OFF Operating sound of solenoid (clicking sound) is heard
SFLH Turns ABS solenoid (SFLH) ON / OFF Operating sound of solenoid (clicking sound) is heard
SRRR Turns ABS solenoid (SRRR) ON / OFF Operating sound of solenoid (clicking sound) is heard
SRRH Turns ABS solenoid (SRRH) ON / OFF Operating sound of solenoid (clicking sound) is heard
SRLR Turns ABS solenoid (SRLR) ON / OFF Operating sound of solenoid (clicking sound) is heard
SRLH Turns ABS solenoid (SRLH) ON / OFF Operating sound of solenoid (clicking sound) is heard
SMF (BA-SOL) Turns TRC solenoid (SRLH) ON / OFF Operating sound of solenoid (clicking sound) is heard
SMR Turns TRC solenoid SMR ON / OFF Operating sound of solenoid (clicking sound) is heard
SFRR & SFRH Turns ABS solenoid SFRR & SFRH ON / OFF Operating sound of solenoid (clicking sound) is heard
SFLR & SFLH Turns ABS solenoid SFLR & SFLH ON / OFF Operating sound of solenoid (clicking sound) is heard
SRH & SRR Turns ABS solenoid SRRR & SRRH ON / OFF Operating sound of solenoid (clicking sound) is heard
SRLR & SRLH Turns ABS solenoid SRLR & SRLH ON / OFF Operating sound of solenoid (clicking sound) is heard
SFRH & SFLH Turns ABS solenoid SFRH & SFLH ON / OFF Operating sound of solenoid (clicking sound) is heard
SOL RELAY Turns ABS solenoid relay ON / OFF Operating sound of relay (clicking sound) is heard
ABS MOT RELAY Turns ABS motor relay ON / OFF Operating sound of relay (clicking sound) is heard
ABS WARN LIGHT Turns ABS warning light ON / OFF Observe combination meter
VSC WARN LIGHT Turns VSC warning light ON / OFF Observe combination meter
SLIP INDI LIGHT Turns SLIP indicator light ON / OFF Observe combination meter
BRAKE WARN LIGHT Turns BRAKE warning light ON / OFF Observe combination meter
VSC/BR WARN BUZ Turns VSC / BRAKE warning buzzer ON / OFF Buzzer is heard
STOP LIGHT RELAY Turns stop light ON / OFF Stop light comes on