FixVault
Home › Toyota › 2007 › Camry Solara SE, 2D Convertible › Repair and Diagnosis › Engine Performance › System › Engine Control System (3MZ-FE) › Throttle Body › Removal

Throttle Body: Removal

  1. DRAIN ENGINE COOLANT (See  COOLANT  ) 
  2. REMOVE FRONT SUSPENSION UPPER BRACE CENTER 
    1. Remove the 2 nuts and upper brace.
  3. REMOVE V-BANK COVER SUB-ASSEMBLY 
    1. Using a 5 mm socket hexagon wrench, remove the 3 nuts.
    2. Remove the V-bank cover.
      Fig 1: Locating V-Bank Cover Nuts
      G05245800Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE AIR CLEANER INLET ASSEMBLY 
  5. REMOVE AIR CLEANER ASSEMBLY 
  6. REMOVE INTAKE AIR RESONATOR 
    1. Remove the ventilation hose No. 2.
    2. Remove the fuel vapor feed hose from the 2 hose clamps.
    3. Loosen the air cleaner hose clamp bolt, and then remove the intake air resonator.
      Fig 2: Locating Ventilation Hose No. 2 And Fuel Vapor Feed Hose
      G05128721Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE THROTTLE BODY ASSEMBLY 
    1. Disconnect the throttle control motor & throttle position sensor connector.
    2. Disconnect the water by-pass hose No. 2.
    3. Disconnect the water by-pass hose No. 3.
      Fig 3: Locating Water By-Pass Hose No. 3 And 2
      G05128722Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 2 bolts, 2 nuts and throttle body.
    5. Remove the gasket.
      Fig 4: Locating Throttle Body With Bolts And Nuts
      G05245803Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault