Rear Coil Spring: Installation

INSTALL REAR COIL SPRING
1. Install the coil spring to the rear axle housing.
  HINT:
  
  Fit the lower end of the coil spring into the gap of the spring lower seat.
  
  Fig 1: Identifying Rear Axle Housing Coil Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TEMPORARILY TIGHTEN REAR SHOCK ABSORBER
1. Install the shock absorber and temporarily tighten the bolt.
  
  Fig 2: Identifying Rear Shock Absorber Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
STABILIZE SUSPENSION
1. Jack down the vehicle.
2. Bounce the vehicle up and down several times to stabilize the suspension.
FULLY TIGHTEN REAR SHOCK ABSORBER
1. Fully tighten the bolt.
  Torque: 98 N*m (1, 000 kgf*cm, 72 ft.*lbf)
  
  Fig 3: Identifying Rear Shock Absorber Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR BRAKE TUBE FLEXIBLE HOSE
1. Install the 2 flexible hoses with 2 new clips.
2. Using SST, install the 2 brake tubes onto the flexible hose.
  SST 09023-00101
  
  Torque:
  
  for use without SST
  
  15 N*m (155 kgf*cm, 11 ft.*lbf)
  
  for use with SST
  
  14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  HINT:
  - Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
  - This torque value is effective when SST is parallel to a torque wrench.
    
    Fig 4: Identifying Brake Tubes With SST
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FILL RESERVOIR WITH BRAKE FLUID (See BRAKE FLUID )
BLEED BRAKE LINE (See BRAKE FLUID )
CHECK FLUID LEVEL IN RESERVOIR (See BLEEDING )
CHECK FOR BRAKE FLUID LEAKAGE
INSTALL REAR WHEEL
Torque: 112 N*m (1, 137 kgf*cm, 82 ft.*lbf)