Ultrasonic Sensor: Installation

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. INSTALL ULTRASONIC SENSOR 
   1. Install the ultrasonic sensor with the retainer.
      Fig 1: Identifying Ultrasonic Sensor With Retainer

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Connect the ultrasonic sensor connector.
2. INSTALL REAR BUMPER COVER  (See INSTALLATION )
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

   Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)