Crankshaft Position Sensor: Removal

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. REMOVE ENGINE UNDER COVER NO.1 
   1. Remove the 6 screws, 2 clips and under cover.
      Fig 1: Locating Under Cover Screws And Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. REMOVE FRONT FENDER APRON SEAL RH 
   1. Remove the clip, 2 bolts and apron seal.
      Fig 2: Locating Clip, Bolts And Apron Seal

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. REMOVE CRANKSHAFT POSITION SENSOR 
   1. Disconnect the sensor connector.
   2. Remove the bolt and sensor.
   Fig 3: Locating Crankshaft Position Sensor With Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002