FixVault
Home › Toyota › 2007 › Highlander Limited, AWD › Repair and Diagnosis › External Pages › Different car › Section 40 (Brake Control System) › Steering Angle Sensor › Installation

Steering Angle Sensor: Installation

WARNING: This page is about a different car, the 2007 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STEERING ANGLE SENSOR 
    1. Align the locating pins, attach the 6 claws and install the sensor to the spiral cable.
  2. INSPECT SPIRAL CABLE SUB-ASSEMBLY (See  REMOVAL  ) 
    Fig 1: Attaching Claws And Installing Sensor To Spiral Cable
    G05189389Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL SPIRAL CABLE SUB-ASSEMBLY (See  INSTALLATION  ) 
  4. INSTALL STEERING COLUMN COVER (See  INSTALLATION  ) 
  5. POSITION SPIRAL CABLE  (See INSTALLATION )
  6. INSTALL TILT LEVER BRACKET (See  INSTALLATION  ) 
  7. INSPECT STEERING WHEEL CENTER POINT (See  INSTALLATION  ) 
  8. INSTALL STEERING WHEEL ASSEMBLY (See  INSTALLATION  ) 
  9. INSTALL STEERING PAD ASSEMBLY (See  INSTALLATION  ) 
  10. INSPECT STEERING PAD ASSEMBLY 
    1. Inspect the steering pad (see ON-VEHICLE INSPECTION ).
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
    NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  13. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see CHECK MODE PROCEDURE ).
About FixVault