FixVault
Home › Toyota › 2007 › Highlander Limited, AWD › Repair and Diagnosis › External Pages › Different variant/trim › Section 39 (Brake Control System - Hybrid) › Steering Angle Sensor › Installation

Steering Angle Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL STEERING ANGLE SENSOR 
    1. Install the steering angle sensor to the spiral cable sub-assembly.
      Fig 1: Identifying Claws And Steering Angle Sensor
      G05202837Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Engage the claws securely.
      • Do not damage the claws.
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH STEERING ANGLE SENSOR  (See REMOVAL )
  3. INSTALL STEERING COLUMN COVER UPPER  (See INSTALLATION )
  4. INSTALL STEERING COLUMN COVER LOWER  (See INSTALLATION )
  5. ADJUST SPIRAL CABLE  (See INSTALLATION )
  6. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  7. INSPECT STEERING WHEEL CENTER POINT 
  8. INSTALL STEERING PAD  (See INSTALLATION )
  9. INSTALL STEERING WHEEL NO.2 COVER LOWER  (See DISPOSAL )
  10. INSTALL STEERING WHEEL NO.3 COVER LOWER  (See DISPOSAL )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. INSPECT STEERING PAD  (See DISPOSAL )
  13. INSPECT SRS WARNING LIGHT 

    (See DIAGNOSIS SYSTEM )

  14. CHECK AND CLEAR DTC 

    (See DTC CHECK / CLEAR  )

  15. PERFORM INITIALIZATION 

    Some systems need initialization after reconnecting the negative battery cable. (See INITIALIZATION )

About FixVault