FixVault
Home › Toyota › 2007 › Highlander Limited, AWD › Repair and Diagnosis › External Pages › Different variant/trim › Section 39 (Brake Control System - Hybrid) › Steering Angle Sensor › Removal

Steering Angle Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. PRECAUTION 

    (See AIRBAG SYSTEM )

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    (See AIRBAG SYSTEM )

  3. PLACE FRONT WHEEL FACING STRAIGHT AHEAD 
  4. REMOVE STEERING WHEEL NO.3 COVER LOWER  (See REMOVAL )
  5. REMOVE STEERING WHEEL NO.2 COVER LOWER  (See REMOVAL )
  6. REMOVE STEERING PAD  (See INSTALLATION )
  7. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL )
  8. REMOVE STEERING COLUMN COVER LOWER  (See REMOVAL )
  9. REMOVE STEERING COLUMN COVER UPPER  (See REMOVAL )
  10. REMOVE SPIRAL CABLE SUB-ASSEMBLY WITH STEERING ANGLE SENSOR  (See REMOVAL )
  11. REMOVE STEERING ANGLE SENSOR 
    1. Disengage the 6 claws and remove the steering angle sensor from the spiral cable sub-assembly.
      Fig 1: Identifying Claws And Steering Angle Sensor
      G05202837Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault