FixVault
Home › Toyota › 2007 › Land Cruiser › Repair and Diagnosis › External Pages › Different car › Section 35 (Engine Immobilizer) › Data List/Active Test

Data List/Active Test

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ DATA LIST 

    HINT:

    Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

    1. Connect the intelligent tester (with CAN VIM) to the DLC3.
    2. Turn the ignition switch ON.
    3. Read the DATA LIST by following the directions on the tester screen.

      Transponder key ECU assembly: 

      TRANSPONDER KEY ECU (DATA LIST)

      Item Measurement Item/Display (Range) Normal Condition
      KEY SW Unlock warning switch signal / ON or OFF OFF: No key is in ignition key cylinder
      ON: Key is in ignition key cylinder
      IG SW Ignition switch signal / ON or OFF OFF: Ignition switch OFF or ACC
      ON: Ignition switch ON
      IMMOBILIZER Immobilizer system status / SET or UNSET UNSET: Ignition switch ON
      SET: No key is in ignition key cylinder
      RESPONSE Transponder chip data / NG or OK NG: Data error
      OK: Data OK
      FRAME Transponder chip data / NG or OK NG: Data error
      OK: Data OK
      SERIAL NUMBER Transponder chip data / NG or OK NG: Data error
      OK: Data OK
      ENCRYPT CODE Transponder chip data / NG or OK NG: Data error
      OK: Data OK
      STATUS Transponder chip data / NG or OK NG: Data error
      OK: Data OK
      BCC Transponder chip signal / NG or OK NG: Incorrect data sent
      OK: Correct data sent
      SUB KEY Sub-key code signal / NO MATCH or MATCH NOMATCH: Unmatched sub-key code is sent
      MATCH: Registered sub-key code is sent
      MASTER KEY Master key code signal / NOMATCH or MATCH NOMATCH: Unmatched master key code is sent
      MATCH: Registered master key code is sent
      REGIST SUB CODE Number of registered sub-keys / min.: 0, max.: 3 Number of registered sub-keys
      REGIST MAS CODE Number of registered master keys / min.: 0, max.: 5 Number of registered master keys
      REG CODE SPACE Memory space for key code registration / NOT FUL or FULL NOT FUL: Possible to register more key codes
      FULL: Cannot register any more key codes
      +B +B judgment / NORMAL or BREAK NORMAL: Battery supply is normal
      BREAK: Battery supply is malfunctioning
      ANTENNA COIL Transponder key coil condition / NORMAL or FAIL NORMAL: Transponder key coil is normal
      FAIL: Transponder key coil is malfunctioning
      G-CODE SUPPORT - NOT SUP: G-code is not supported
      SUPPORT: G-code is supported
  2. PERFORM ACTIVE TEST 

    HINT:

    Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The Data List can be displayed during the ACTIVE TEST.

    1. Connect the intelligent tester (with CAN VIM) to the DLC3.
    2. Turn the ignition switch ON.
    3. Perform the ACTIVE TEST by following the directions on the tester screen.

      Transponder key ECU assembly: 

      TRANSPONDER KEY ECU (ACTIVE TEST)

      Item Test Details Diagnostic Note
      SECURITY INDIC Turn security indicator ON/OFF -
About FixVault