FixVault
Home › Toyota › 2007 › Matrix Base, Automatic › Repair and Diagnosis › Body & Frame › Door Locks › Door Lock › Front Door Lock › Inspection

Front Door Lock: Inspection

  1. INSPECT FRONT DOOR LOCK ASSEMBLY LH 
    1. Apply battery voltage and inspect the door lock motor operation, as shown in the illustration and table.

      Standard 

      MEASURING CONDITION CHART

      Measuring condition Specified Condition
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1      		 Lock
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4      		 Unlock

      If the result is not as specified, replace the door lock assembly.

      Fig 1: Inspecting Front Door Lock Assembly LH
      G05196053Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TERMINAL SPECIFIED CONDITION CHART

      Terminal No. Door Lock Position Specified Condition
      7 - 9 Lock Below 1 Ω
      - OFF -
      7 - 10 Unlock Below 1 Ω

      If the result is not as specified, replace the door lock assembly.

    3. Measure the resistance according to the value(s) in the table below.
      Fig 2: Identifying Front Door Lock Assembly LH Lock And Unlock Conditions
      G05196054Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

      TERMINAL SPECIFIED CONDITION CHART

      Terminal No. Door Lock Position Specified Condition
      7 - 8 Lock Below 1 Ω
      - OFF -
      7 - 9 Unlock Below 1 Ω

      If the result is not as specified, replace the door lock assembly.

  2. INSPECT FRONT DOOR LOCK ASSEMBLY RH 
    1. Apply battery voltage and inspect the door lock motor operation, as shown in the illustration and table.

      Standard 

      MEASURING CONDITION CHART

      Measuring condition Specified Condition
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1      		 Lock
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4      		 Unlock

      If the result is not as specified, replace the door lock assembly.

      Fig 3: Inspecting Front Door Lock Assembly RH
      G05196055Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TERMINAL SPECIFIED CONDITION CHART

      Terminal No. Door Lock Position Specified Condition
      6 - 8 Lock Below 1 Ω
      - OFF -
      5 - 8 Unlock Below 1 Ω

      If the result is not as specified, replace the door lock assembly.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TERMINAL SPECIFIED CONDITION CHART

      Terminal No. Door Lock Position Specified Condition
      7 - 8 Lock 10 kΩ or higher
      - OFF -
      7 - 8 Unlock Below 1 Ω

      If the result is not as specified, replace the door lock assembly.

      Fig 4: Identifying Lock And Unlock Position Of Door Lock Assembly
      G05196056Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault