Rear Center Seat Outer Belt Assembly: Installation

INSTALL REAR SEAT BELT ASSEMBLY OUTER CENTER
1. Before installing the ELR, check the ELR.
  1. Gently tilt the ELR and pull the belt. Check that the belt will not lock within 15° of tilt in all directions Then check that the belt will lock when over 45° of tilt is applied. If the operation is not as specified, replace the rear seat belt assembly outer center.
  Fig 1: Identifying ELR Lock Angle
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the rear seat belt assembly outer center with the bolt.
  Torque: 41.2 N*m (420 kgf*cm, 30 ft.*lbf)
3. After installing the ELR, check the ELR.
  NOTE: The check should be performed with the assembly installed.
  1. With the belt installed, check that the belt locks when it is pulled out quickly. If the operation is not as specified, replace the rear seat belt assembly outer center.
4. Check the fastening function of the child restraint system.
  NOTE: The check should be performed with the assembly installed.
  1. When the belt is pulled out fully, the belt should automatically try to retract.
  2. After the belt has fully retracted, the belt should be able to be pulled out and retracted again. If the operation is not as specified, replace the rear seat belt assembly outer center.
INSTALL REAR SEAT CUSHION ASSEMBLY AND REAR SEATBACK ASSEMBLY
INSTALL DECK TRIM COVER REAR
INSTALL BACK DOOR WEATHERSTRIP
INSTALL LUGGAGE COMPARTMENT TRAY
INSTALL DECK FLOOR BOX REAR
INSTALL DECK BOARD SUB-ASSEMBLY
INSTALL DECK BOARD NO. 2
INSTALL TONNEAU COVER ASSEMBLY
INSTALL REAR DOOR OPENING TRIM LH
INSTALL REAR DOOR OPENING TRIM RH
INSTALL REAR DOOR SCUFF PLATE LH
INSTALL REAR DOOR SCUFF PLATE RH