Key Slot: Inspection

INSPECT KEY SLOT

Remove the key slot (see REMOVAL ).

Measure the resistance of the key slot.

Standard resistance

RESISTANCE TESTER CONNECTION SPECIFICATION

Tester Connection	Condition	Specified Condition
3 (KSW2) - 2 (COM)	Key is in key slot	10 kΩ or higher

If the result is not as specified, replace the key slot.

Fig 1: Identifying Key Slot Connector Terminals

G04473246

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Inspect the key slot illumination.
1. Connect the battery positive (+) lead from the battery to terminal 2 and the battery negative (- ) lead to terminal 6, then check that the illumination comes on.
  OK : Illumination comes on.
  
  Fig 2: Identifying Key Slot Connector Terminals
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002