Inspection Procedure

1. Disconnect the stereo component amplifier connectors.
2. Measure the resistance according to the values in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester connection	Condition	Specified condition
   GND - Body ground	Always	Below 1 Ω
   GND2 - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the values in the table below.

   Standard voltage 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester connection	Condition	Specified condition
   B+ - GND	Always	10 to 14 V
   B2+ - GND	Always	10 to 14 V
   ACC - GND	Ignition SW ACC	10 to 14 V

Fig 1: Identifying S10 And S11 Stereo Component Amplifier Connectors Terminal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE