Front Axle Hub: Installation

1. Install the 2 bolts, nuts and front axle assembly LH with the 2 bolts and nuts to the shock absorber assembly front LH.

   Torque: 230 N*m (2,350 kgf*cm, 170 ft.*lbf) 

   NOTE:

   • Only when reusing the bolts and nuts, apply the small amount of engine oil to the screw part of the nuts.
     Fig 1: Locating Bolts And Nuts

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   • Do not excessively push out the front axle assembly LH.
   • Be careful not to damage the outboard joint boot.
   • Be careful not to damage the speed sensor rotor.

1. Install the front disc brake caliper assembly LH with the 2 bolts to the steering knuckle LH.

   Torque: 104 N*m (1,060 kgf*cm, 77 ft.*lbf) 

1. Using a socket wrench (30mm), install a new axle hub LH nut.

   Torque: 294 N*m (3,000 kgf*cm, 217 ft.*lbf) 

   Fig 2: Locating Axle Hub LH Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 bolts and separate the front disc brake caliper assembly LH from the steering knuckle LH.
   NOTE: Use a string or other device to keep the brake caliper from hanging down.

1. Install the front disc brake caliper assembly LH with the 2 bolts to the steering knuckle LH.

   Torque: 104 N*m (1,060 kgf*cm, 77 ft.*lbf) 

Fig 3: Locating Axle Hub LH Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a socket wrench (30 mm), install a new axle hub LH nut.

   Torque: 294 N*m (3,000 kgf*cm, 217 ft.*lbf) 

2. Using a chisel and hammer, stake the axle hub LH nut.
Fig 4: Installing Front Axle Hub LH Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

1. Inspect front wheel alignment (See ADJUSTMENT ).

1. ABS WITH EBD SYSTEM (See TEST MODE PROCEDURE ).
2. ABS WITH EBD & BA & TRAC & VSC SYSTEM (See TEST MODE PROCEDURE ).