FixVault
Home › Toyota › 2007 › Sienna CE › Repair and Diagnosis › Suspension › Wheel Alignment › Suspension System › Front Lower Ball Joint › Installation

Front Lower Ball Joint: Installation

  1. INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH 
    1. Install the lower ball joint assembly front LH and tighten the nut.

      Torque: 123 N*m (1,250 kgf*cm, 91 ft.*lbf) 

    2. Install a new cotter pin.
      NOTE: If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
  2. INSTALL FRONT AXLE ASSEMBLY LH 

    HINT:

    (See COMPONENTS )

  3. INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1 LH 

    HINT:

    (See COMPONENTS )

  4. INSTALL TIE ROD ASSEMBLY LH 

    HINT:

    (See COMPONENTS )

  5. INSTALL FRONT DISC 
  6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH 

    HINT:

    (See COMPONENTS )

  7. INSTALL SPEED SENSOR FRONT LH 

    HINT:

    (See COMPONENTS )

  8. INSTALL FRONT AXLE HUB LH NUT 

    HINT:

    (See COMPONENTS )

  9. INSTALL FRONT WHEEL 

    Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

  10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT 

    HINT:

    (See ADJUSTMENT  )

  11. CHECK ABS SPEED SENSOR SIGNAL 

    w/o VSC: (See HOW TO PROCEED WITH TROUBLESHOOTING ).

    w/ VSC: (See HOW TO PROCEED WITH TROUBLESHOOTING ).

About FixVault