Transmission Assembly: Remove & Replace
WARNING: This page is about the Tacoma Base, 2D Pickup, 4WD, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Base,In-Line4,4WD,5 Spd Trans | 4.7 | 2.8 | C | |
| Combination Procedure: CLUTCH PRESSURE PLATE: Remove & Replace: | ||||
| 0.3 | C | |||
| Combination Procedure: CLUTCH RELEASE BEARING: Remove & Replace: | ||||
| 0.2 | C | |||
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: | ||||
| Rear | 0.7 | B | ||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.5 | C | |||
| Combination Procedure: TRANSFER CASE ASSEMBLY: Overhaul: | ||||
| 4.8 | A | |||