CONSULT-II Start Procedure

WARNING: This page is about a different car, the 2007 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Turning ignition switch off when performing CAN diagnosis could cause CAN memory to be erased.

Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.

Fig 1: Connecting CONSULT-II And CONSULT-II Converter To Data Link Connector
If necessary, turn ON the ignition switch.
Touch "START (NISSAN BASED VHCL)" or system shortcut key (e.g.: ENGINE) on the screen.

Fig 2: CONSULT-II Function Screen Display - START (NISSAN BASED VHCL)
Touch necessary system on "SELECT SYSTEM" screen. If necessary system is not indicated, check power supply and ground of system control unit. If it is normal, refer to "CONSULT-II Data Link Connector (DLC) Circuit ".

Fig 3: CONSULT-II Function Screen Display - Select System
Select the desired part to be diagnosed on the "SELECT DIAG MODE" screen.

Fig 4: CONSULT-II Function Screen Display - SELECT DIAG MODE