FixVault
Home › Toyota › 2008 › 4Runner Limited, 4.7 T, AWD › Repair and Diagnosis › Brakes › Traction Control › Brake Control › Steering Angle Sensor › Installation

Steering Angle Sensor: Installation

  1. INSTALL STEERING ANGLE SENSOR 
    1. Attach the 2 claws to install the steering angle sensor.
      Fig 1: Locating Steering Sensor Claws
      G05556642Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the steering angle sensor connector.
      Fig 2: Identifying Steering Sensor Connector
      G05556643Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL TURN SIGNAL SWITCH ASSEMBLY  (See INSTALLATION )
  3. INSPECT SPIRAL CABLE SUB-ASSEMBLY  (See INSPECTION )
  4. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  5. INSTALL SPIRAL CABLE SUB-ASSEMBLY  (See INSTALLATION )
  6. INSTALL STEERING COLUMN COVER UPPER  (See INSTALLATION )
  7. INSTALL STEERING COLUMN COVER LOWER 
  8. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  9. INSTALL STEERING PAD ASSEMBLY  (See INSTALLATION )
  10. INSTALL STEERING WHEEL COVER LOWER NO. 2 
  11. INSTALL STEERING WHEEL COVER LOWER NO. 3 
  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  13. INSPECT SRS WARNING LIGHT  (See INSTALLATION )
  14. PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION 

    HINT:

    Perform steering angle sensor zero point calibration (see CALIBRATION  ).

  15. CHECK SPEED SENSOR SIGNAL 

    HINT:

    Check the speed sensor signal (see TEST MODE PROCEDURE  ).

About FixVault