FixVault
Home › Toyota › 2008 › Avalon XLS › Repair and Diagnosis › Accessories & Equipment › Cruise Control Systems › Cruise Control System › Laser Sensor › Installation

Laser Sensor: Installation

  1. INSTALL LASER SENSOR 
    1. Install the laser sensor so that the claw contacts the flat surface around the hole on the front bumper mounting reinforcement.
      NOTE: Do not insert the claw into the hole on the front bumper mounting reinforcement.
    2. Engage the clamp.
    3. Connect the connector.
  2. INSTALL FRONT BUMPER REINFORCEMENT  (See INSTALLATION )
  3. INSTALL FRONT BUMPER ENERGY ABSORBER  (See INSTALLATION )
    Fig 1: Identifying Laser Sensor
    G05005652Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL FRONT BUMPER ASSEMBLY (w/o Fog Light)  (See INSTALLATION )
  5. INSTALL FRONT BUMPER ASSEMBLY (w/ Fog Light)  (See INSTALLATION )
  6. INSTALL RADIATOR GRILLE SUB-ASSEMBLY  (See INSTALLATION )
  7. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  8. VEHICLE PREPARATION FOR FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light)  (See ADJUSTMENT )
  9. PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light)  (See ADJUSTMENT )
  10. INSPECT FOG LIGHT AIMING (w/ Fog Light)  (See ADJUSTMENT )
  11. ADJUST FOG LIGHT AIMING (w/ Fog Light)  (See ADJUSTMENT )
  12. ADJUST LASER SENSOR 

    (See ADJUSTMENT  )

About FixVault