Skid Control Sensor: Installation

1. Clean the contact surface of the axle hub and a new skid control sensor.
   NOTE: Prevent foreign matter from attaching to the sensor rotor.
2. Place the skid control sensor on the axle hub so that the connector is positioned as shown in the illustration.
   Fig 1: Identifying Skid Control Sensor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST and a press, install the skid control sensor to the axle hub.
   NOTE:

   • Do not tap the skid control sensor with a hammer directly.
   • Check that there should be no foreign matter on the skid control sensor detection portion.
   • Press in the skid control sensor straight and slowly.
     Fig 2: Identifying Skid Control Sensor To Axle Hub

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the rear axle hub & bearing assembly with the 4 bolts.

   Torque: 80 N*m (816 kgf*cm, 59 ft.*lbf) 

   Fig 3: Identifying Rear Axle Hub Bearing Assembly Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Aligning the matchmarks, install the rear disc.

   HINT:

   When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.

   Fig 4: Identifying Matchmarks

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

See INSPECTION

1. Connect the connector to the skid control sensor.

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

HINT:

See ADJUSTMENT

HINT:

See TEST MODE PROCEDURE  for ABS system, TEST MODE PROCEDURE  for VSC system