FixVault
Home › Toyota › 2008 › Camry Solara SLE, 2D Convertible › Repair and Diagnosis › Brakes › Traction Control › Brake Control › Steering Angle Sensor › Installation

Steering Angle Sensor: Installation

  1. INSTALL STEERING ANGLE SENSOR 
    1. Align the locating pins, engage the claws, and install the steering angle sensor to the spiral cable.
    Fig 1: Identifying Steering Angle Sensor Claws
    G04978275Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH STEERING ANGLE SENSOR  (See INSTALLATION )
  3. INSTALL STEERING COLUMN COVER  (See INSTALLATION )
  4. INSTALL STEERING LOWER COLUMN COVER  (See INSTALLATION )
  5. ADJUST SPIRAL CABLE  (See INSTALLATION )
  6. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  7. INSPECT STEERING WHEEL CENTER POINT  (See INSTALLATION )
  8. INSTALL STEERING PAD  (See INSTALLATION )
  9. INSTALL NO. 2 STEERING WHEEL COVER LOWER  (See INSTALLATION )
  10. INSTALL NO. 3 STEERING WHEEL COVER LOWER  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (See INITIALIZATION )
  12. INSPECT STEERING PAD  (See INSTALLATION )
  13. INSPECT SRS WARNING LIGHT 

    HINT:

    (See DIAGNOSIS SYSTEM )

About FixVault