Section 16 (Engine Control System (2AZ-FE)): ECM: Installation

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL ECM BRACKET NO.2
1. Install the ECM bracket with the 2 screws.
  
  Fig 1: Locating ECM Bracket No.2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ECM BRACKET
1. Install the ECM bracket with the 2 screws.
  
  Fig 2: Locating ECM Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ECM
1. Install the 2 wire harness clamps.
2. Connect the 5 ECM connectors.
3. Install the ECM with the 2 nuts.
  
  Fig 3: Locating ECM
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
INSTALL INSTRUMENT PANEL FINISH LOWER PANEL RH
HINT:

See INSTALLATION
INSTALL INSTRUMENT PANEL NO.1 UNDER COVER SUB-ASSEMBLY
HINT:

See INSTALLATION
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
HINT:

See INSTALLATION
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

See INSTALLATION
CONNECT BATTERY NEGATIVE TERMINAL
SYSTEM INITIALIZE
HINT:

See CUSTOMIZE PARAMETERS