FixVault
Home › Toyota › 2008 › Corolla LE, Standard › Repair and Diagnosis › External Pages › Different car › Section 111 (Engine Control System (3MZ-FE)) › ECM › Installation

Section 111 (Engine Control System (3MZ-FE)): ECM: Installation

WARNING: This page is about a different car, the 2008 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ECM BRACKET NO.2 
    1. Install the ECM bracket with the 2 screws.
      Fig 1: Identifying ECM Bracket With Screws
      G05128344Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ECM BRACKET 
    1. Install the ECM bracket with the 2 screws.
      Fig 2: Identifying ECM Bracket With Screws
      G05128343Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL ECM 
    1. Install the 2 wire harness clamps.
      2. Fig 3: Identifying ECM Wire Harness Clamps
      G05128342Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the 5 ECM connectors.
    3. Install the ECM with the 2 nuts.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

  4. INSTALL INSTRUMENT PANEL FINISH LOWER PANEL RH 
  5. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1 
  6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH 
  7. INSTALL FRONT DOOR SCUFF PLATE RH 
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  9. INITIALIZE SYSTEM 
About FixVault