FixVault
Home › Toyota › 2008 › Corolla LE, Standard › Repair and Diagnosis › External Pages › Different car › Section 24 (Engine Control System (3MZ-FE)) › ECM › Installation

Section 24 (Engine Control System (3MZ-FE)): ECM: Installation

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ECM BRACKET NO.2 
    1. Install the ECM bracket with the 2 screws.
      Fig 1: Locating ECM Bracket No.2 Screws
      G05128344Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ECM BRACKET 
    1. Install the ECM bracket with the 2 screws.
      Fig 2: Locating ECM Bracket Screws
      G05128343Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL ECM 
    1. Install the 2 wire harness clamps.
    2. Connect the 5 ECM connectors.
    3. Install the ECM with the 2 nuts.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

      Fig 3: Locating ECM Connectors
      G05128342Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL INSTRUMENT PANEL FINISH LOWER PANEL RH 
  5. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1 
  6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH 
  7. INSTALL FRONT DOOR SCUFF PLATE RH 
  8. CONNECT BATTERY NEGATIVE TERMINAL 
  9. INITIALIZE SYSTEM 
About FixVault