FixVault
Home › Toyota › 2008 › Highlander Base, FWD › Repair and Diagnosis › External Pages › Different variant/trim › Section 7 (Engine Control System (Hybrid)) › Crankshaft Position Sensor › Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE NO. 1 ENGINE UNDER COVER  (See REMOVAL )
  2. SEPARATE FRONT FENDER LINER RH 
  3. REMOVE FRONT FENDER APRON SEAL RH 
  4. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the bolt, and then remove the crankshaft position sensor.
    Fig 1: Locating Crankshaft Position Sensor With Bolt
    G05245825Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault