FixVault
Home › Toyota › 2008 › Highlander Hybrid › Repair and Diagnosis › Engine Performance › Engine Control System (Hybrid) › Crankshaft Position Sensor › Removal

Crankshaft Position Sensor: Removal

  1. REMOVE NO. 1 ENGINE UNDER COVER  (See REMOVAL )
  2. SEPARATE FRONT FENDER LINER RH 
  3. REMOVE FRONT FENDER APRON SEAL RH 
  4. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the bolt, and then remove the crankshaft position sensor.
    Fig 1: Locating Crankshaft Position Sensor With Bolt
    G05245825Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault