Data List / Active Test
- DATA LIST
HINT:
Using the Techstream DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to shorten labor time.
- Connect the Techstream to the DLC3.
- Turn the ignition switch ON.
- Read the DATA LIST according to the display on the tester.
Transponder key ECU:
TRANSPONDER KEY ECU DATA LISTItem Measurement Item/ Display (Range) Normal Condition Diagnostic Note KEY SW Unlock warning switch signal/ ON or OFF OFF: Key is in ignition key cylinder
ON: No key is in ignition key cylinder- IGSW Ignition switch signal/ON or OFF OFF: Ignition switch is OFF or in the ACC position
ON: Ignition switch is in the ON position- IMMOBILIZER immobilizer system status/ SET or UNSET UNSET: Without key
SET: Ignition switch ON- PERMIT (Start) Permit (Start) signal/ NG or OK NG: No permission for engine start
OK: Engine start permission- RESPONSE Transponder chip data/ NG or OK NG: Data error
OK: Data OK- FRAME ERROR Transponder chip data/ NG or OK NG: Data error
OK: Data OK- Different Serial Number Transponder chip data/ NG or OK NG: Data error
OK: Data OK- Different Encrypt Code Transponder chip data/ NG or OK NG: Data error
OK: Data OK- Abnormal Status Transponder chip data/ NG or OK NG: Data error
OK: Data OK- Bcc Malfunction Transponder chip data/ NG or OK NG: Incorrect data sending
OK: Correct data sending- SUB KEY Sub-key code signal/ NOMATCH or MATCH NOMATCH: Unmatched sub-key code is sent
MATCH: Sub-key code is sent- MASTER KEY Master key code signal/ NO MATCH or MATCH NOMATCH: Unmatched master key code is sent
MATCH: Master key code is sent- Transponder S-Code Number of registered sub-key/ min. 0, max. 15 Number of registered sub-key - Transponder M-Code Number of registered master key/ min. 0, max. 15 Number of registered master key - REG CODE SPACE Memory space for key codes registration/ NOT FULL or FULL NOT FULL: Possible to register more key codes
FULL: Cannot register any more key codes- +B Power source/ BREAK or NORMAL BREAK: Power source open
Normal: Power source normal- ANTENNA COIL Transponder key amplifier coil condition/ NORMAL or FAIL Normal: Antenna coil is normal
FAIL: Antenna coil is malfunctioning-
- ACTIVE TEST
HINT:
Performing the Techstream ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to shorten labor time. The DATA LIST can be displayed during the ACTIVE TEST.