Abs And Traction Actuator: Reassembly

INSTALL BRAKE ACTUATOR BOLT CUSHION
1. Install the 3 cushions to the actuator.
INSTALL BRAKE ACTUATOR BOLT HOLDER
1. Install the 2 bolt holders to the actuator.
INSTALL ABS AND TRACTION ACTUATOR ASSEMBLY
NOTE: Do not remove the hole plug before connecting the brake tube. New actuators are filled with brake fluid.
1. Set the actuator on the bracket.
  NOTE:
  - Insert the cushion to the pin of the bracket securely.
    
    Fig 1: Identifying Cushion To Pin Of Bracket
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - The clearance between the bolt holder and bracket is less than 1.0 mm (0.039 in.).
  - The projection should be set as shown in the illustration.
    
    Fig 2: Identifying Clearance Between Bolt Holder And Bracket
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 nuts to assemble the actuator and bracket.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 3: Identifying Nuts And Actuator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002