Inspection Procedure
- CHECK CAN COMMUNICATION SYSTEM
- Check if the CAN communication system DTC is output (see DIAGNOSIS SYSTEM
).
Result
DTC RESULT DESCRIPTIONResult Proceed to DTC is not output A DTC is output B
B: REPAIR CAN COMMUNICATION SYSTEM
A: Go to next step.
- Check if the CAN communication system DTC is output (see DIAGNOSIS SYSTEM
).
- PERFORM ACTIVE TEST BY TECHSTREAM (BRAKE WARNING LIGHT)
- Select the Active Test, generate a control command, and then check that BRAKE warning light operates.
ABS / VSC / TRAC:
CONTROL RANGE AND DIAGNOSTIC NOTETester Display Test Part Control Range Diagnostic Note Brake Warning Lamp BRAKE warning light Warning light ON / OFF Observe combination meter OK: The BRAKE warning light turns on or off.
OK: REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY
NG: Go to next step.
- Select the Active Test, generate a control command, and then check that BRAKE warning light operates.
- INSPECT COMBINATION METER
- Inspect the combination meter (see HOW TO PROCEED WITH TROUBLESHOOTING ).
NG: REPLACE COMBINATION METER
OK: REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY