Diagnostic Trouble Code Chart
NOTE:
When removing any parts, turn the ignition switch to OFF.
HINT:
- Using SST 09843-18040, connect terminal TC and CG of the DLC3.
- If no abnormality is found when inspecting parts, inspect the ECU and ground points for poor contact.
- If a DTC is displayed during the DTC check, check the circuit for the DTC listed in the table below. For details of each DTC, refer to the page indicated.
- When 2 or more DTCs are recorded and the problem cannot be identified, perform circuit inspection of the other DTCs.
DIAGNOSTIC TROUBLE CODE CHART
| DTC Code | Detection Item | Trouble Areas |
|---|---|---|
| C0200/31 | Right Front Wheel Speed Sensor Signal Malfunction |
|
| C0205/32 | Left Front Wheel Speed Sensor Signal Malfunction |
|
| C0210/33 | Right Rear Wheel Speed Sensor Signal Malfunction |
|
| C0215/34 | Left Rear Wheel Speed Sensor Signal Malfunction |
|
| C0226/21 | SFR Solenoid Circuit |
|
| C0236/22 | SFL Solenoid Circuit |
|
| C0246/23 | SRR Solenoid Circuit |
|
| C0256/24 | SRL Solenoid Circuit |
|
| C0273/13 | Open or Short Circuit in ABS Motor Relay Circuit |
|
| C0274/14 | Short to B+ in ABS Motor Relay Circuit |
|
| C0278/11 | Open or Short Circuit in ABS Solenoid Relay Circuit |
|
| C0279/12 | Short to B+ in ABS Solenoid Relay Circuit |
|
| C1235/35 | Foreign Object is Attached on Tip of Front Speed Sensor RH |
|
| C1236/36 | Foreign Object is Attached on Tip of Front Speed Sensor LH |
|
| C1238/38 | Foreign Object is Attached on Tip of Rear Speed Sensor RH |
|
| C1239/39 | Foreign Object is Attached on Tip of Rear Speed Sensor LH |
|
| C1241/41 | Low Battery Positive Voltage |
|
| C1243/43 | Acceleration Sensor Stuck Malfunction |
|
| C1244/44 | Open or Short in Deceleration Sensor Circuit |
|
| C1245/45 | Acceleration Sensor Output Malfunction |
|
| C1248/48 | Open Circuit in Rear Differential Lock |
|
| C1249/49 | Open in Stop Light Switch Circuit |
|
| C1251/51 | Open in Pump Motor Circuit |
|
| C1337/37 | Different Diameter Tire Malfunction |
|
(*1): Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed.
- Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
- Clear the DTC.