Throttle Body: Installation

INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY
1. Install a new gasket and the throttle with motor body with the 4 bolts.
  Torque: 11 N*m (112 kgf*cm, 9 ft.*lbf)
  
  Fig 1: Identifying Throttle With Motor Body Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the throttle motor connector.
3. Connect the water by-pass hose No. 4.
  
  Fig 2: Identifying Water By-Pass Hose No 4
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the water by-pass hose No. 5.
  
  Fig 3: Identifying Water By-Pass Hose No 5
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER ASSEMBLY
1. Install the air cleaner with the 2 bolts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 4: Identifying Hose Clamps & Air Cleaner Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Tighten the 2 hose clamps.
3. Install the 2 wire harness clamps.
4. Connect the mass air flow meter connector.
5. Connect the vacuum hose.
  
  Fig 5: Identifying Mass Air Flow Meter Connector & Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Connect the ventilation hose No. 2.
  
  Fig 6: Identifying Ventilation Hose No. 2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
ADD ENGINE COOLANT (See REPLACEMENT )
CHECK FOR ENGINE COOLANT LEAKAGE (See REPLACEMENT )
INSTALL V-BANK COVER
1. Install the V-bank cover with the 2 nuts.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
  
  Fig 7: Identifying V-Bank Cover Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002