FixVault
Home › Toyota › 2009 › Avalon Limited › Repair and Diagnosis › External Pages › Different car › Section 29 (Brake Control System) › Steering Angle Sensor › Installation

Steering Angle Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STEERING ANGLE SENSOR 
    1. Install the steering angle sensor to the spiral cable.
      NOTE:
      • Engage the claws securely.
      • Do not damage the claws.
  2. INSPECT SPIRAL CABLE  (See INSPECTION )
  3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
    Fig 1: Identifying Steering Angle Sensor From Spiral Cable Claws
    G05001649Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL SPIRAL CABLE  (See INSTALLATION )
  5. CENTER SPIRAL CABLE  (See INSTALLATION )
  6. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  7. INSTALL STEERING PAD  (See INSTALLATION )
  8. INSPECT STEERING PAD  (See INSTALLATION )
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  10. INSPECT SRS WARNING LIGHT  (See INSTALLATION )
About FixVault